Credit: Dan Walton
Order Link: https://www.amazon.com/WLJH-Instrument-Replacement-Interior-License/dp/B0798RXC5V
Interiores Tuning Ulises
Order Link: https://www.facebook.com/diegoalonso.martinezhernandez/
Notes:
- This is an overlay with a “Real” Carbon Fiber look. While it is not actual Carbon Fiber, it does have a legit look.
- It’s a pretty legit kit but some of the pieces that are installed on moving parts such as cup holder cover, front lower cubby and upper cubby (SE trim) were all a little big around the edges and wouldn’t open properly until a shaved a little off with a razor which wasn’t noticeable.
Community Member Credit: Jerry Herrera
Notes:
- Overall, pretty much a direct fit. See reference photo on the bracket that needs to be drilled out a little.
- They look really good in the car and give that bucket seat type feel while driving.
- You do lose your heated seats and electronic adjustments. But I prefer performance over comfort.
Member Credit: Nealoc187
The factory gauges are about 1.25-1.5 inches deep – the circuit board sits that far back from the black plastic surface on which the gauges are mounted (the circuit board mounts on the back of the white plastic part of the “sandwich”, probably more than 1.5″ away from the black surface on which the gauges are mounted – no need to modify it in any way) Once you remove the factory gauge there is tons of room (depth) to mount a gauge in it’s place, The PLX gauge only takes up about 3/8 inch of depth.
Credit: Samuel Stevens
Things needed :
- Neodymium magnetic door stopper x 3
- Steel 2.2” screw
- Water tank stopper
- Matte black paint spray can
