Community Member Credit: angryfx

1- Take the 6 clips out of the grill.

PB281278.jpg

2- The grill is now free but there are 4 clips that are attached towards the radiator that you use
a plier to take out…. close up of the clip…

PB281280.jpg

3-the holes were where the clips were held in place to the bumper.

PB281282.jpg

4-the headlights are held by 4 screws. 2 on top and 2 at thhe bottom… one behind the front bumper
and the other behind the wheel wells.

PB281286.jpg

PB281291.jpg

PB281292.jpg

5-to remove the bumper you will have to remove 10-15 bolts depending on how many you have under the car
by the bottom plastic cover… but you have to remove 2 screws that hold the bumper to the fender…on each side..

PB281301.jpg

PB281298.jpg

hard to get a nice pic so these are some supporting pics..
PB281300.jpg

6- once you unbolt these 2 bolts then you will see that the bumper will kinda wobble… they are still
held in place by 2 clips right under the headlight housing… if you pull the bumper you will see them.

PB281305.jpg

PB281306.jpg

PB281303.jpg

7- when pulling on them be careful i broke 1 of the clips but when putting them back in i found it
not to be bi issue with just 1 clip instead of 2 but still be careful…

8- with the bumper off or hanging by 1 or 2 screws at the bottom… you can now access the bolt under
the headlight. this shoul be the last bolt to remove… unplug all th electrical harnesses/wiring…
take em out gently…

PB281307.jpg

PB281308.jpg

PB281327.jpg

PB281328.jpg

9- once you take the headlights out you can now exchange the ballast (3 screws) held in under the headlight.
and the light bulbs..(unclip the metal pin and take the bulbs out..

PB281321.jpg

this is the ballast ( i didnt know until today)

PB281318.jpg

now take the silver holder out by twistin like a regular bulb

PB281314.jpg

you will see the rear side of the bulb

PB281320.jpg

unclip thes metal sprins by pushing them with your thumb n finger n open the latch….

PB281315.jpg

10- do it to the other side and put the bulbs and the ballasts back in …..

PB281317.jpg

PB281321.jpg

11- if you are going to do DTRL SWAP now is the time …. cut the black wire cover tape

PB281343.jpg

12- i used a nipper to cut the tabs because i was lazy…

PB281349.jpg

13 – please refer to dtrl swap thread for more info if you have any question.

14 – put headlight back in and connect all the wires

PB281335.jpg

PB281356.jpg

15 – put the bumper back in …..

PB281357.jpg

16 – PUT GRILL BACK IN AND CHECK THE LIGHT TO SEE OR OF THEM ARE WORKING WELL CLEAN AFTER
YOUR MESS AND FEEL GOOD DONE!!!!

PB281365.jpg

Video: