Member Credit: mightymax
Next, take off the plastic covers a pick or small screwdriver will work
Remove 6 14mm nuts from towers
You need to relocate the service port for the A/C, very simple just pull it up out of the white clip and move the clip to the opposite side of the port. This will give you more than enough clearance to tighten the 19mm nut, and save your tech some hassle when it comes time for A/C service.
Install your FSTB, might take some finnagling to get the bolts to line up right, but it should fit, retorque the nuts and tighten the allen/14mm brass nut on each side and the 19mm adjustment nut
This was the trickiest part. Your OEM plastics will not fit over the FSTB, you can keep them off or do as I did and trim to fit. I just eyeballed it and took the dremel to it and sanded off the burrs. Reinstall your plastics and your good to go!!!
Pic with OEM cover installed
Still have clearance after spacer install, and I haven’t seen any sign of rubbing on hood 
Additional Pics by Member Scui
Comments are closed.