Search Results for: shifter modification

Results 1 - 30 of 86Page 1 of 3
Results per-page: 10 | 20 | 50 | 100

Cheap 5MT ES Shifter Bushing on 4thgen Nissan Maxima

Relevance: 100%      Posted on: 03/26/2018

Cheap 5MT ES Shifter Bushing on 4thgen Nissan Maxima

Member Credit: schmellyfart I was thinking about making a solid shifter bushing when I came across this on a Sentra forum. It uses Energy Suspension sway bar bushings. Part # 9.5101 I paid $20 for a set of two. Only downside is that you can't buy them individually. The shifts don't…

How to Install RedLineGoods Automatic Transmission Shift Boot on 2002-2004 Nissan Maxima

Relevance: 68%      Posted on: 12/27/2020

How to Install RedLineGoods Automatic Transmission Shift Boot on 2002-2004 Nissan Maxima

Credit: redlinegoods To install on an automatic, you need to wedge the shift boot between the shifter assembly and the trim piece surrounding it. Therefore it is necessary to remove that surrounding trim. When removing the trim piece surrounding the shifter, hazard switch and power outlet, the thing to be…

Installing ES Bushings under the Shifter Assembly on 5thgen Nissan Maxima

Relevance: 59%      Posted on: 09/27/2020

Installing ES Bushings under the Shifter Assembly on 5thgen Nissan Maxima

Community Member Credit: Rochester Part: Shifter Stabilizer Bushings - Nissan Maxima - 7.1115 Order Link: https://www.energysuspensionparts.com/7.1115 Here are the notes on removing the shifter trim and center console. Pictures follow. Remove the ashtray and the screw behind the ashtray. (picture) Unsnap the shifter trim by gently pushing your fingers into…

Gallery of Secret Sauce Intake Manifold (SSIM) Setups

Relevance: 55%      Posted on: 02/24/2018

Gallery of Secret Sauce Intake Manifold (SSIM) Setups

This is a gallery of Secret Sauce Intake Manifold (SSIM) Setups. The SSIM (Secret Sauce Intake Manifold) was created years ago by member SR20DEN. This involves cutting the shelf out of the main chamber of the upper intake manifold and removing the VIAS assembly. This will still lose a little low end power,…

How to Disassemble Center Console

Relevance: 51%      Posted on: 12/23/2017

How to Disassemble Center Console

Member Credit: TEQ-NIQ Step 1: Remove shifter knob - Shifter knob is made of two parts, the leather handle, and the lower aluminum-looking cone-shaped piece. Grasp the cone-shaped lower piece, rotate counter-clockwise and pull down at the same time to release from shifter handle. Once this is done, there is a…

How to Perform Navigation Bypass on 2011 7thgen Maxima

Relevance: 48%      Posted on: 12/29/2017

How to Perform Navigation Bypass on 2011 7thgen Maxima

Member Credit: FredMCMC20 This is for models with Navigation only. This essentially will allow you to use the navigation/touchscreen interface while the car is moving (as opposed to being limited to just what is on the screen). This is incredibly useful if you're sick of only being able to scroll…

How to Install Leather Emergency Brake Boot

Relevance: 43%      Posted on: 01/25/2018

How to Install Leather Emergency Brake Boot

Member Credit: shift_ice I've always thought the 5th gen. Maxima emergency brake boot was chintzy looking, particularly the fact that the end of the plastic base is visible through the rubber boot. I purchased a black Italian leather shift boot with titanium stitching from redlinegoods.com. It was shipped quickly and came…

How to Re-Wire Fog Lights for 5thgen Nissan Maxima (2000-2001)

Relevance: 42%      Posted on: 10/19/2020

How to Re-Wire Fog Lights for 5thgen Nissan Maxima (2000-2001)

Community Member Credit: Kevin Kryzda Tools necessary: 10mm socket and an extension Flathead screwdriver (or pry tool) Wire/Side Cutters or Wire Strippers Wire taps or soldering tools Before You Start: The purpose of this modification is to re-wire your fog light relay under your hood to receive signal from an…

Helpful Install Information on the Various Types of eBay Headers

Relevance: 41%      Posted on: 01/30/2018

Helpful Install Information on the Various Types of eBay Headers

When Maxima owners get the infamous P0420 check engine light code for bad pre-cats, the best route is to go with eBay headers. However, when you search eBay there are various types of header listings that pop-up. This post goes into a little more details about what modification are required…

How to Swap Climate Control Bulb on 5thgen Maxima

Relevance: 40%      Posted on: 03/17/2018

How to Swap Climate Control Bulb on 5thgen Maxima

Member Credit: Anthony Carter Tools Needed: Hard Plastic Blade to Remove Shifter Cover and Bent Box (Flathead may mess up your dash) #2 Phillips Small Phillips Small Flathead to help disconnect electrical connectors in back of climate control unit 8mm Socket w/ Extension. Pop out the vent up top. Pop…

Josh’s 1998 Gen2 Full VQ35DE 6-Speed 4thgen Nissan Maxima

Relevance: 39%      Posted on: 12/24/2020

Josh's 1998 Gen2 Full VQ35DE 6-Speed 4thgen Nissan Maxima

Owner: Josh Go Hard Neal Year: 1998 Model: Maxima Color: White Trim: SE Engine: VQ35DE Full Swap (Not 3.0 Timing) Transmission: 6-Speed Manual Mod List: 2011 Maxima Motor 2002 Maxima 6 Speed HLSD 2002 ECU Stock Tuned 6th Gen Maxima True CAI Fidanza Lightweight Flywheel Nisformance Stage 2 Clutch Altima 3.5 Headers Custom Y-Pipe…

Installing Audi R8 Coilpacks on VQ30DE Engine 3.0 / 3.0 DE-K (4thgen/5thgen)

Relevance: 36%      Posted on: 12/07/2019

Installing Audi R8 Coilpacks on VQ30DE Engine  3.0 / 3.0 DE-K (4thgen/5thgen)

Member Credit: Ronny Para This article will help you install Audi R8 Coil Packs on your VQ30DE. For those that don’t know, Audi coilpacks are stronger and better than Nissan coilpacks. They add better mpg and more HP/TQ. It works on bone stock vehicles or highly modified vehicles. Nissan Coilpack…

How to Perform a 6-speed Swap on 4thgen Nissan Maxima

Relevance: 34%      Posted on: 01/09/2017

How to Perform a 6-speed Swap on 4thgen Nissan Maxima

Member Credit: MAXSE5SPD REQUIRED PARTS 02+ 6spd maxima transmission. Sentra spec-v will also work (if you use Maxima bell housing) 5.5 gen 6spd maxima shifter assembly 5.5 gen 6spd maxima shifter cables 6spd drivers side axle 6spd pass axle* 6spd frame trans mount 6spd transmission mount 6spd flywheel 6spd clutch 5spd…

Install an 1999 Maxima Unorthodox Racing Underdrive Pulley (UDP) on 2002 Maxima

Relevance: 33%      Posted on: 12/25/2017

Install an 1999 Maxima Unorthodox Racing Underdrive Pulley (UDP) on 2002 Maxima

Member Credit: Greg Curious whether my Unorthodox Racing underdrive pulley (UDP) from my 1999 Maxima SE would fit the 2002 Maxima, I arranged another appointment with Unorthodox to test fit the pulley to the new VQ35 motor. The staff at Unorthodox were very interested in the test fit as well…

How to Replace AC Control Amplifier on 6thgen Maxima

Relevance: 33%      Posted on: 02/10/2018

How to Replace AC Control Amplifier on 6thgen Maxima

Member Credit: Sparky This 2006 Nissan Maxima came in with the complaint that the gauges and the a/c controls did not work. After the obvious fuse checks I went to the most common location for this problem in Nissan Maximas. The problem is located behind the a/c control panel and…

How to Calibrate 6th Gen Maxima Cluster/Odometer Needles

Relevance: 33%      Posted on: 01/14/2018

How to Calibrate 6th Gen Maxima Cluster/Odometer Needles

Member Credit: Albert Jandura If you are looking to customize the lighting of LED's on your Nissan Maxima cluster/odometer, you will need to re-calibrate the needles. The needles need to come off as part of the modification process and if not properly calibration the RPMs and MPH readings will be…

Corey Mott’s 2005 6-Speed Nissan Altima SE-R (Modded & Tuned 269WHP)

Relevance: 32%      Posted on: 07/18/2020

Corey Mott's 2005 6-Speed Nissan Altima SE-R (Modded & Tuned 269WHP)

Owner: Corey Mott Year: 2005 Model: Altima SE-R Color: Smoke Metallic Engine: VQ35DE Transmission: 6-Speed Manual Mod List: Ionic Dynamics Carbon Fiber Engine Cover Mishimoto Catch Can Mishimoto Radiator Mishimoto Oil Cap Mishimoto Carbon Fiber Radiator Cap Mishimoto Power Steering Reservoir Moog Front Sway End Links Moog Rear Sway End Links…

1999 to 1995 4thgen Maxima ECM Swap a Success!

Relevance: 31%      Posted on: 07/07/2018

1999 to 1995 4thgen Maxima ECM Swap a Success!

Member Credit: whlimi I was running a cali spec ECM in my 3.5 swapped 99. I had 14 codes, most of them emissions related (damn cali spec) and TCM codes (running SSV4). Got myself a 95 5spd ECM from the junk yard and decided I would take the plunge and swap…

2J-Racing Side Exit Exhaust Installed on 4thgen Nissan Maxima

Relevance: 31%      Posted on: 03/26/2018

2J-Racing Side Exit Exhaust Installed on 4thgen Nissan Maxima

Member Credit: schmellyfart I've been mulling over a side exit exhaust off and on the past year. I pulled the trigger on Black Friday as 2J-Racing had their 3" B15 side exit exhaust on sale. Having only eyeballed pictures of it on their website and those that others have posted, I…

How to Change the Nissan Navigation Disc

Relevance: 30%      Posted on: 02/05/2017

How to Change the Nissan Navigation Disc

Member Credit: Nismo4Life07 Tools Needed: - New Updated DVD - Flathead Screwdriver (or knife) Step 1: - Its easiest to access the DVD player if the car is in Neutral so put the car in neutral and place the E-Brake. Step 2: - Open up the small door in front…

Navi Ashtray Mod on 5thgen Nissan Maxima

Relevance: 30%      Posted on: 12/07/2019

Navi Ashtray Mod on 5thgen Nissan Maxima

Member Credit: perkman87 I have has multiple emails on the Navi install on my 2003 maxima via taking out the ashtray. The Navigation Model is the Magellan Maestro. It matches the TE edition perfect as you can see it is also silver and black just like most interiors in the…

VQ35DE Swapped and Superchaged 1998 Maxima

Relevance: 29%      Posted on: 05/06/2018

VQ35DE Swapped and Superchaged 1998 Maxima

Member Credit: mastercater7 aka Zack I wanted to post on here to share my project as well as do my best to help others. I am a member on maxima.org, but as far as having a boosted VQ35, there are not many people. Thus, needing input or help with problems can…

Installing a Stillen Front Strut Tower Brace (FSTB) on 5thgen Maxima

Relevance: 29%      Posted on: 12/25/2017

Installing a Stillen Front Strut Tower Brace (FSTB) on 5thgen Maxima

Member Credit: Greg Stillen Front Strut Tower Brace before install. The simple purpose of this ingenious device is to lock the tops of the shock towers together in the engine compartment. Result is the suspension "box" is complete, and the car corners much flatter than stock, with a greater degree…

Maxime Daigneault’s 2002 Modded VQ35DE 6-Speed Nissan Altima

Relevance: 28%      Posted on: 04/05/2021

Maxime Daigneault's 2002 Modded VQ35DE 6-Speed Nissan Altima

Owner: Maxime Daigneault Year: 2002 Model: Altima Color: BX4 Opal Blue Metallic Transmission: 6-Speed Manual Trim: SE Mod List: 3.5" Intake NWP 75MM Throttle Body NWP 5-Piece Intake Spacer Kit Upper Intake Manifold Gutted SSIM Ported and Polish Home Made by Me the Lower Just Polish NWP Block-off Plate AEM 340LPH Fuel…

Nissan Maxima 6-Speed Transmission Fix/Upgrade to Sentra Spec V

Relevance: 28%      Posted on: 12/17/2019

Nissan Maxima 6-Speed Transmission Fix/Upgrade to Sentra Spec V

Member Credit: 6spd_Hayes Disclaimer: If you attempt any of what you see from my post, you do so at your own risk. The following is a summary of my experience. The Car: 2002 Maxima SE Transmission: 6 speed, HLSD, RS6F51A Mileage: 174,000 mi. (approx.) Situation: November 1st, 2014. I jumped…