Search Results for: neutral safety switch

Results 1 - 30 of 95Page 1 of 4
Results per-page: 10 | 20 | 50 | 100

Nissan Maxima P1706 Neutral Position Switch

Relevance: 100%      Posted on: 06/22/2019

Nissan Maxima P1706 Neutral Position Switch

Member Credit: EddyMaxx Adding some helpful information regarding this code P1706. The sensor was broken and I almost couldn't find it. Replacing the sensor resolved the code. I ran into this issue and decided to document my findings for anyone needing to troubleshoot this. P1706 Nissan DTC: Park Neutral Position…

How to Perform Idle Air Volume Learning Procedure

Relevance: 88%      Posted on: 01/15/2017

How to Perform Idle Air Volume Learning Procedure

This applies to the 2000-2001 5thgens. Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied. Learning will be cancelled if any of the following conditions are missed for even a moment. Battery voltage: More than 12.9V (At idle) Engine coolant temperature: 70 -…

4thgen Nissan Maxima 5-Speed Swap Electrical Modifications

Relevance: 72%      Posted on: 12/24/2018

4thgen Nissan Maxima 5-Speed Swap Electrical Modifications

Member Credit: ajm8127 I did a 5 speed swap two weeks or so ago and there was a lot of time spent wading through the FSM pages to make sure the electrical system of the automatic chassis was compatible with the manual transmission, and the functionality of a manual chassis. This…

How to Replace Ignition Switch on 4thgen Maxima

Relevance: 68%      Posted on: 01/01/2018

How to Replace Ignition Switch on 4thgen Maxima

Member Credit: pmohr This howto is for the quick and easy task of replacing the ignition switch. If you have to jiggle the key around for the car to start, have to do any special tricks for it to work, whatever. This whole process shouldn't take but 10 minutes, if…

How to Calibrate 6th Gen Maxima Cluster/Odometer Needles

Relevance: 55%      Posted on: 01/14/2018

How to Calibrate 6th Gen Maxima Cluster/Odometer Needles

Member Credit: Albert Jandura If you are looking to customize the lighting of LED's on your Nissan Maxima cluster/odometer, you will need to re-calibrate the needles. The needles need to come off as part of the modification process and if not properly calibration the RPMs and MPH readings will be…

How to Reset SRS Lamp/Airbag Light

Relevance: 51%      Posted on: 02/12/2017

How to Reset SRS Lamp/Airbag Light

Member Credit: EddyMaxx There are various scenarios that can trigger a flashing Airbag light. These scenarios range from unplugging the seats and installing alarms all the way to messing with steering wheel and audio controls. The procedure below is directly from the Nissan Service Manual. If this procedure DOES NOT work,…

Infiniti I35 / 5thgen Nissan Maxima No Start Condition Due to Lock Mode (FIX INSIDE)

Relevance: 44%      Posted on: 10/20/2020

Infiniti I35 / 5thgen Nissan Maxima No Start Condition Due to Lock Mode (FIX INSIDE)

LOCK MODE FUNCTION When the starting operation is carried out five or more times consecutively under the following conditions, IVIS (NATS) will shift the mode to one which prevents the engine from being started. - Unregistered ignition key is used. - IMMU or ECM’s malfunctioning. ESCAPE FROM LOCK MODE 1.…

How to Change the Nissan Navigation Disc

Relevance: 42%      Posted on: 02/05/2017

How to Change the Nissan Navigation Disc

Member Credit: Nismo4Life07 Tools Needed: - New Updated DVD - Flathead Screwdriver (or knife) Step 1: - Its easiest to access the DVD player if the car is in Neutral so put the car in neutral and place the E-Brake. Step 2: - Open up the small door in front…

How to Set Your Horn Chirp (ON/OFF) With Remote

Relevance: 41%      Posted on: 01/08/2017

How to Set Your Horn Chirp (ON/OFF) With Remote

Member Credit: EddyMaxx There may be times where you are wondering these two things: Why doesn't my car beep when I lock the doors? How do I get rid of that annoying horn beep when I lock my doors. Well below are your answers. These are the two modes that…

5thgen Maxima Power Window Calibration

Relevance: 41%      Posted on: 02/10/2018

5thgen Maxima Power Window Calibration

Member Credit: Sparky This 2003 Nissan Maxima came in with the complaint that the passenger front window would go down on it’s own. What I determined was that when the window was raised up, it would automatically cycle down about six inches. If the glass, motor or regulator have been…

5thgen Nissan Maxima Quick Guide to No-Start Problems

Relevance: 40%      Posted on: 12/02/2019

5thgen Nissan Maxima Quick Guide to No-Start Problems

Member Credit: maxiiiboy Symptom (when turning the ignition switch to START) Likely Cause No Crank, No Nothing (not even dashboard lights) If the car starts with a boost, then the battery is bad. If not, suspect the ignition switch, the battery cables, fuses, or ground/power distribution. No Crank, just a…

Auto Roll Up/Down of All 4-Windows with OEM Remote on 2005 Maxima

Relevance: 40%      Posted on: 07/07/2018

Auto Roll Up/Down of All 4-Windows with OEM Remote on 2005 Maxima

Member Credit: rguerra7 I just wanted to share my experience, I now have all 4 windows auto up/down and all 4 roll up/down with the remote on my 2005 Nissan Maxima. I had to buy: The master switch with all auto switches. The rear auto switches. Rear window power motors. The…

How to Perform ECU Reset, Throttle Pedal Release, TVCP, Idle Volume Learning

Relevance: 38%      Posted on: 01/15/2017

How to Perform ECU Reset, Throttle Pedal Release, TVCP, Idle Volume Learning

This applies to 2002-2003 5thgens. Member Credit: maxima dude Before attempting any of the following procedures, it is advisable that you read through the instructions thoroughly and familiarize yourself with them. A stop watch or an analog clock with a second’s needle will be useful. ( i counted outloud becuz…

How to Add Heated Steering Function on 07-08 Nissan Maxima’s

Relevance: 34%      Posted on: 03/11/2018

How to Add Heated Steering Function on 07-08 Nissan Maxima's

Member Credit: Chris Goss In my 08, I put the heated steering wheel switch to the left of the steering wheel just because it was easier and shorter wire runs. Run a wire from the battery with an waterproof inline fuse holder with a 10a fuse in it. Connect that…

How to Install Zex Nitrous Kit

Relevance: 32%      Posted on: 01/05/2017

How to Install Zex Nitrous Kit

Source Credit: EddyMaxx These are instructions on how to install a wet nitrous kit in your 6thgen. This is pretty straight forward but if you have any doubt please take it to someone who knows how to install these systems. The Zex model used for 6thgens is usually the 82016…

5thgen Nissan Maxima Under Hood Lighting Mod DIY

Relevance: 32%      Posted on: 12/07/2019

5thgen Nissan Maxima Under Hood Lighting Mod DIY

Member Credit: TunerMax I had a free SMD LED board from HIDextra and decided to install some under hood lighting, something they should have done at Nissan. Thought I'd share this with you guys I'm sure there are quite a few of you that would be very interested in doing…

How to Program 95-99 4thgen Maxima Key Fob Remote

Relevance: 30%      Posted on: 05/13/2018

How to Program 95-99 4thgen Maxima Key Fob Remote

Official PDF: Keyfob Programming 4thgen Programming Instructions 1. Close and lock all doors with the driver’s side power lock/unlock switch. 2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this…

How to Remove Stock Radio on 07-08 6thgen Maxima

Relevance: 30%      Posted on: 07/07/2018

How to Remove Stock Radio on 07-08 6thgen Maxima

Member Credit: Eddy Disconnect battery negative terminal. Remove the CVT finisher. Place the shift lever in the Drive position. Separate the chrome finisher from the shift knob by pushing it down. Remove the shift knob (1) by removing the spring clip and pulling up. Then remove the chrome finisher (2).…

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Relevance: 28%      Posted on: 06/23/2020

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Member Credit: myer84 I finally finished installing my last mod. For a while I’ve been searching for a shift light indicator, but nothing as big as a Monster Tach or anything that would make the car look ricey. My idea of a shift light was something that would be small…

Rewire Fogs to Turn-on with Parking Lights or Independently

Relevance: 28%      Posted on: 01/28/2018

Rewire Fogs to Turn-on with Parking Lights or Independently

Member Credit: 05ALTIMASE-R & Earl Johnson The key to this install is basically taking the 2 wires from the fog light switch on stalk and cutting them out of the OEM circuit. Then taking the two wires and putting one to a ground and running the other into the engine compartment to the IPDM (relay/fuse block). The last step is pulling the…

How to Change your 7thgen CVT Transmission Fluid (Drain/Refill)

Relevance: 26%      Posted on: 12/29/2017

How to Change your 7thgen CVT Transmission Fluid (Drain/Refill)

Member Credit: Ghozt I just did my CVT transmission fluid drain/fill the other day, I'm at ~44,000 miles and premium maintenance service plan recommended every 40,000 while standard recommended every 60,000. With how I drive I figured it's about time so why not. I got my fluid on fleabay, picked…

5thgen Maxima – Wiring Map Lights to Function When Dome Turns on

Relevance: 26%      Posted on: 12/07/2019

5thgen Maxima - Wiring Map Lights to Function When Dome Turns on

Member Credit: TunerMax I know some of you were interested in wiring your Map light(s) to illuminate when the Dome turned on, and some of you already have. Either way, I thought I'd let you know what I've figured out. The best way I see to do it properly: Tap…

P1610 NISSAN – Lock Mode (5thgen Maxima Won’t Start)

Relevance: 26%      Posted on: 02/11/2018

P1610 NISSAN - Lock Mode (5thgen Maxima Won't Start)

This seems to be common on the 2002-2003 Nissan Maxima's. Below is a procedure you can follow before going to the dealer. Possible causes: Faulty or not programmed ignition key Faulty IMMU Faulty Engine Control Module (ECM) This code is usually triggered when a not registered or damaged key is…

How to Install LEDs on Hazard/Defroster

Relevance: 25%      Posted on: 01/01/2018

How to Install LEDs on Hazard/Defroster

Member Credit: wariow3 This is a how-to to change the current lights in the Hazards and Rear Defroster buttons. This application is for 95-99 Maxima's but might work also for other max's and cars. Thanks to JackBauer for his help on the hazards and rear defroster. Difficulty: Easy to moderate.…

Cefiro A33 TDM Nissan Maxima Folding Mirror Pinout

Relevance: 25%      Posted on: 12/16/2019

Cefiro A33 TDM Nissan Maxima Folding Mirror Pinout

Member Credit: vastmax I acquired some genuine TDM Nissan mirrors a while ago with the convex glass, sidemarkers, puddle lights, heated, and of course, folding functionality. I ran my wires from the door to inside the car through a small grommet that is located right beside where the bundled door…

How to Install CXJ Performance 3pc Thermal Phenolic Spacers

Relevance: 25%      Posted on: 01/08/2017

How to Install CXJ Performance 3pc Thermal Phenolic Spacers

Member Credit: CXJ Performance DISCONNECT THE BATTERY FIRST! This would be great time to change the spark plugs as well. Remove the upper intake manifold. Once the manifold has been removed it will look like the picture shown below: STOP EVERYTHING! PLACE RAGS INTO THE CHAMBERS. If a bolt is dropped…

4thgen Maxima Automatic to 5-Speed Transmission Swap

Relevance: 25%      Posted on: 10/19/2020

4thgen Maxima Automatic to 5-Speed Transmission Swap

Community Member Credit: VQPower Automatic to 5spd Conversion Details for Nissan Maximas: Parts Needed: 5spd Tranny (Try and Get the I30 Lsd or Canadian Maxima Lsd if Possible ? Doubt It) Both Manual Drive Shafts (if You Have Abs You Need Specific Ones, if You Don't Have Abs You Can…