Search Results for: fan write up

Results 1 - 30 of 44Page 1 of 2
Results per-page: 10 | 20 | 50 | 100

How to Change Blower Motor / Resistor on 2000-2003 5thgen Nissan Maxima

Relevance: 100%      Posted on: 01/23/2021

How to Change Blower Motor / Resistor on 2000-2003 5thgen Nissan Maxima

Community Member Credit: maximaboy12 Hey Guys so my blower would make a lil rubbing noise so I went under there and cleaned it out. And might as well make a write up for all the n00bies out there. I saw a lot of pics for the 4th gen but not…

How to Replace OEM Spark Plug Tube Seals on Valve Cover (Save $$$)

Relevance: 78%      Posted on: 02/13/2021

How to Replace OEM Spark Plug Tube Seals on Valve Cover (Save $$$)

Community Member Credit: R&D Factory Here are DIY instructions on how to replace the OEM seals on your Nissan VQ engine. At R&D Factory, we service many Nissans and Infiniti's daily and run into the same valve cover/spark plug o-ring leak. About 75% of the vehicles that we serve have…

How to Make Idle Air Volume Relearn Stick on 5thgen Nissan Maxima

Relevance: 65%      Posted on: 12/17/2020

How to Make Idle Air Volume Relearn Stick on 5thgen Nissan Maxima

Community Member Credit: Thrillho In case you've disrupted your throttle body and need to perform the Idle Air Volume Relearn, you've probably noticed that it doesn't "stick" , meaning it worked fine for the time being and then it didn't. I am using the Nissan Data Scan app with an…

Daily Driving My 5thgen Nissan Maxima on 100% E85 Fuel (1+Year Review)

Relevance: 40%      Posted on: 01/31/2021

Daily Driving My 5thgen Nissan Maxima on 100% E85 Fuel (1+Year Review)

Community Member Credit: Eddy Just wanted to share my experience and review with E85 over the past 1+ year on daily driving on E85 through all seasons. Not a lot of feedback out there on using E85 for daily driving or in general for the Nissan Maxima. Prior to doing…

Z32 300ZX TT MAF for Supercharged 4thgen Nissan Maxima

Relevance: 39%      Posted on: 10/19/2020

Z32 300ZX TT MAF for Supercharged 4thgen Nissan Maxima

Community Member Credit: iansw So I've been asked to do a write-up on how to make the Z32 MAF setup work with the JWT ECU + 370cc Injectors while Supercharged on the charged side. Symptoms: With the Z32 MAF on the charged side and stock Stillen piping the car idles…

2002 Nissan Maxima AEM 340LPH Fuel Pump Swap & Fuel Filter Replacement E85

Relevance: 35%      Posted on: 11/17/2019

2002 Nissan Maxima AEM 340LPH Fuel Pump Swap & Fuel Filter Replacement E85

Community Member Credit: Eddy I just swapped my Walbro 255 Fuel Pump to an AEM 340LPH because I wanted something better suited for E85. I  also did not like the "whine" noise on the Walbro. The AEM 340 does not have the whining noise and works great. I also replaced…

How to Install Aftermarket Fuel Gauge in your Nissan Maxima

Relevance: 33%      Posted on: 07/23/2020

How to Install Aftermarket Fuel Gauge in your Nissan Maxima

Credit: Clutched_tombo Hope this can help anyone that wants to use an aftermarket fuel gauge. May already be a write up on this but I couldn't find it. I decided to go with aftermarket after not being able to find a cluster with one that actually works correctly. Used one…

How to Retain Steering Wheel Controls with ASWC-1 on 6thgen Maxima

Relevance: 32%      Posted on: 01/26/2018

How to Retain Steering Wheel Controls with ASWC-1 on 6thgen Maxima

Member Credit: Lenin Vera This is the installation of the Axxess ASWC-1 aftermarket steering wheel controls on my Pioneer Headunit in my 2004 Nissan Maxima. I did this write up to document my installation and hopefully help some my6thGen.org forum members clarify the installation process. The ASWC-1 adapter from Axxess allows…

How to Install Clear Bumper Lights on 4thgen Nissan Maxima

Relevance: 29%      Posted on: 05/03/2021

How to Install Clear Bumper Lights on 4thgen Nissan Maxima

Community Member Credit: Neo Raven456 Alright, so I know this isn't a complicated procedure, but a lot of people like to know exactly what they're getting into when they go to do a mod. I'm one of those people. I had found a tutorial before, but it seems it has…

How to Remove your 6thgen Headlights

Relevance: 29%      Posted on: 02/10/2017

How to Remove your 6thgen Headlights

Member Credit: Elite Package Hey guys i just recently painted the interior of my lights black to match my car. I just figured i'd write this post to help anyone out by giving "visual" instructions rather then "Text" instructions. So if you decide to tackle this project yourself like i did,…

How to Make Coilbags To Protect Your Coilovers During Winter

Relevance: 29%      Posted on: 01/08/2017

How to Make Coilbags To Protect Your Coilovers During Winter

Member Credit: omahasubaru Materials you will need: - canvas material from a local fabric store. - heavy duty thread - heavy duty velcro - some rope/string or zip ties Tools you will need: - Fabric tape measure - Scissors - Pencil or fabric marker - Sewing machine Other items that may…

How to Make a Flip Flop Trunk on Nissan Maxima

Relevance: 27%      Posted on: 07/07/2018

How to Make a Flip Flop Trunk on Nissan Maxima

Member Credit: Jason Sadler You need 10mm socket, metal drill bit set with a good drill, self tapping screws, 2 hinges, 2 latches, and a friend to help you out when you get tired of drilling or holding the trunk lid up on your back...and yes you need the winnie the…

How to Re-Wire Fog Lights for 5thgen Nissan Maxima (2000-2001)

Relevance: 25%      Posted on: 10/19/2020

How to Re-Wire Fog Lights for 5thgen Nissan Maxima (2000-2001)

Community Member Credit: Kevin Kryzda Tools necessary: 10mm socket and an extension Flathead screwdriver (or pry tool) Wire/Side Cutters or Wire Strippers Wire taps or soldering tools Before You Start: The purpose of this modification is to re-wire your fog light relay under your hood to receive signal from an…

How to Tune your Nissan/Infiniti ECU using Rom Raider and Nisprog/Kern (for only $10)

Relevance: 25%      Posted on: 02/01/2017

How to Tune your Nissan/Infiniti ECU using Rom Raider and Nisprog/Kern (for only $10)

Member Credit: Matt Riney For all you hardcore Nissan/Infiniti enthusiasts, there is finally an open-source solution that allows you to modify and flash ECUs! With a $10 VAG-KKL cable, you can basically flash your own ECU and tune it your to personal comfortable without breaking your wallet. The average tune…

How to Install 2002-2003 5thgen Brakes on 4thgen Maxima

Relevance: 23%      Posted on: 12/25/2018

How to Install 2002-2003 5thgen Brakes on 4thgen Maxima

Member Credit: 95BLKMAX I wanted bigger brakes, but I didnt want to spend a fortune (as much as one would spend, say for a Z32 upgrade, or the 6th gen rotors with Z32 calipers, etc...) for just front brakes. Plus I dont autoX, I just do alot of highway spirited driving;…

How to Install 2007-2012 Altima LED Side Mirrors on Nissan Altima SE-R

Relevance: 22%      Posted on: 02/25/2021

How to Install 2007-2012 Altima LED Side Mirrors on Nissan Altima SE-R

Community Member Credit: Winard Porter So due to the fact that there was little to no info on here regarding the mirror swap, I decided to do a write-up on the process as i experienced it. Please note, you do this at you own risk. Tools Needed: Wire Stripper 24…

How to Fix Bose Random Speaker Cutout on 5thgen Maxima

Relevance: 22%      Posted on: 01/25/2018

How to Fix Bose Random Speaker Cutout on 5thgen Maxima

Member Credit: shift_ice & Chris.s For those who want to try tackling this on their own, below is a write-up by Maxima.org member Chris.s. Be forewarned that a few screws that need to be removed aren't outlined (namely, the front mounting plate) and you need a good toolkit to do this…

2004 Infiniti FX35 Rear Trunk Latch Lift Gate Won’t Open (FIX INSIDE)

Relevance: 22%      Posted on: 04/04/2021

2004 Infiniti FX35 Rear Trunk Latch Lift Gate Won't Open (FIX INSIDE)

Community Member Credit: Eddy I started having issues with my rear trunk latch life gate on my 2004 Infiniti FX35. It just wouldn't open. For some time, I was just removing the trunk 15A fuse where it would reset the latch. It would eventually open. But this ultimately got worse.…

1995-1999 4thgen Nissan Maxima Steering Rack Replacement

Relevance: 22%      Posted on: 05/08/2021

1995-1999 4thgen Nissan Maxima Steering Rack Replacement

Community Member Credit: Kevlo911 I bet over 75% of 4th gen owners have a leaking steering rack and/or worn tie rods... I bought the rack from: https://www.carsteering.com/buynow/1999/Nissan/Maxima/Rack_and_Pinion/80-00386_R I bought the 99se rack because it is stiffer. It comes with new inner tie rods and new o-rings. You should replace the…

1997 Infiniti i30 Automatic to 5-Speed Manual Transmission Swap

Relevance: 21%      Posted on: 02/22/2021

1997 Infiniti i30 Automatic to 5-Speed Manual Transmission Swap

Community Member Credit: i30ds I took my time and saved a bunch of cash for a host goodies. Best ball park guess (includes shipping) $3500... This included a lot of new stuff: Just about the only thing that were used are the shift and control rods, the clutch and brake…

5thgen Nissan Maxima Aluminum Radiator Upgrade (using 4thgen Radiator $100 Bucks)

Relevance: 21%      Posted on: 10/13/2020

5thgen Nissan Maxima Aluminum Radiator Upgrade (using 4thgen Radiator $100 Bucks)

Community Member Credit: Eddy If you are tired of your OEM plastic radiator cracking or just simply looking for an upgrade, the 4thgen radiator is a very good option. It fits perfectly on the 2000-2003 5thgen and only costs around $100 bucks. The quality is great and equal to those…

1999 to 1995 4thgen Maxima ECM Swap a Success!

Relevance: 19%      Posted on: 07/07/2018

1999 to 1995 4thgen Maxima ECM Swap a Success!

Member Credit: whlimi I was running a cali spec ECM in my 3.5 swapped 99. I had 14 codes, most of them emissions related (damn cali spec) and TCM codes (running SSV4). Got myself a 95 5spd ECM from the junk yard and decided I would take the plunge and swap…

2000-2003 How to Install Coilovers on 5thgen Nissan Maxima

Relevance: 18%      Posted on: 04/22/2021

2000-2003 How to Install Coilovers on 5thgen Nissan Maxima

Community Member Credit: Fezzik Here is what the rear Coilover that I tested looked like compared to the stock rear suspension. These are still being tested and are not offered yet. You will first want to measure the car’s wheel gap right now and think of how much u want…

How to Remove your Upper Oil Pan

Relevance: 18%      Posted on: 12/25/2017

How to Remove your Upper Oil Pan

Member Credit: SrgScott Hey guys, I had an oil leak in my upper oil pan, so decided to give you a write-up on how to remove it! I’m going to assume everyone knows how to apply liquid gasket and seals, so I will be leaving that part out. So, if…

How to Replace Front Wheel Bearing on 7thgen Maxima

Relevance: 17%      Posted on: 02/01/2018

How to Replace Front Wheel Bearing on 7thgen Maxima

Member Credit: MaximaDrvr I am completing this write up to help people save some money. You can probably buy all of the needed tools for what the dealership would charge. This was an over $400 quote for each side. Generally, you will replace these in pairs, but it is not absolutely…

How to Install a 2000 5thgen VI Manifold on 4thgen Nissan Maxima

Relevance: 15%      Posted on: 02/16/2020

How to Install a 2000 5thgen VI Manifold on 4thgen Nissan Maxima

Member Credit: sdot82 This write-up is for a 2000-01 VI manifold swap on to 95-99 Maxima. There are many ways to do this swap so first I will number the ways I know how to do this and then go into detail on how to do it. There are a…