| Results 1 - 30 of 119 | Page 1 of 4 |
| Results per-page: 10 | 20 | 50 | 100 |
Relevance: 100% Posted on: 07/07/2018
Member Credit: Jason Sadler You need 10mm socket, metal drill bit set with a good drill, self tapping screws, 2 hinges, 2 latches, and a friend to help you out when you get tired of drilling or holding the trunk lid up on your back...and yes you need the winnie the…
Relevance: 84% Posted on: 09/27/2020
Community Member Credit: Eddy Out of nowhere, I noticed that the trunk on my FX35 was not fully closing. Initially, I thought the actuator was toast and I would need to replace it. When you get the lock, you should be able to hear the trunk latch engage. I wasn't…
Relevance: 66% Posted on: 01/15/2017
This applies to 2002-2003 5thgens. Member Credit: maxima dude Before attempting any of the following procedures, it is advisable that you read through the instructions thoroughly and familiarize yourself with them. A stop watch or an analog clock with a second’s needle will be useful. ( i counted outloud becuz…
Relevance: 64% Posted on: 09/07/2020
Credit to Mijo To Wavy on this nice find. Price: $82.00 (Shipped) Order Link: https://www.ebay.com/itm/Flat-Black-284-PDL-Rear-Trunk-Lip-Spoiler-Wing-For-95-99-NISSAN-Maxima-A32-Sedan-/322429239478 Keywords: Flat Black 284 PDL Rear Trunk Lip Spoiler Wing For 95~99 NISSAN Maxima A32 Sedan
Relevance: 61% Posted on: 07/07/2018
Member Credit: Eddy Disconnect battery negative terminal. Remove the CVT finisher. Place the shift lever in the Drive position. Separate the chrome finisher from the shift knob by pushing it down. Remove the shift knob (1) by removing the spring clip and pulling up. Then remove the chrome finisher (2).…
Relevance: 59% Posted on: 01/01/2021
Credit: the12volt Constant 12V+ White/Red or White/Purple Ignition Switch Harness Starter Black/Yellow or Black/White Ignition Switch Harness Ignition Black/White or Black/Red Ignition Switch Harness Ignition 2 Starter 2 Wire Red/Yellow or Red Ignition Switch Harness Accessory Blue or White/Blue Ignition Switch Harness Tach White/Green ECM, Front of Center Console Neutral…
Relevance: 52% Posted on: 02/05/2017
Note: This is the button on your rear view mirror is you have this function. To program your HomeLink Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door openers (manufactured…
Relevance: 49% Posted on: 08/29/2020
This is just a reference photo of where do find your fuel pump relay on 02-03 5thgen Nissan Maxima's. The location of the fuel pump relay is right under the hood release to the left of where your footrest is. You will need to remove the plastic cover, a sticky…
Relevance: 49% Posted on: 11/11/2019
Member Credit: Theslaking Grabbed a Nissan mirror with LCD from an 09+ Rogue. It was as simple as running wires in a vehicle I already had gutted. At first, I tapped into power upfront from the mirror but that caused too much of a delay with the camera turn on.…
Relevance: 46% Posted on: 01/25/2018
Member Credit: shift_ice I've always thought the 5th gen. Maxima emergency brake boot was chintzy looking, particularly the fact that the end of the plastic base is visible through the rubber boot. I purchased a black Italian leather shift boot with titanium stitching from redlinegoods.com. It was shipped quickly and came…
Relevance: 45% Posted on: 01/08/2017
This article explains the various ways of resetting and/or clearing codes on your 6thgens. It should also work for any of the current generation Nissan and Infiniti vehicles. Clearing the codes will turn off any check engine lights (aka: SEL, CEL, SES, etc..). There is a table of OBDII codes…
Relevance: 44% Posted on: 01/21/2017
Member Credit: shift_ice According to Nissan the 5th Gen Maxima has a "lifetime" filter that never needs changed. In my opinion there is no such thing as a lifetime filter, so I changed mine recently. Many on maxima.org agree that a change is a good idea, and the general consensus…
Relevance: 44% Posted on: 11/30/2020
Community Member Credit: DAlastDON When I bought my 07 maxima one of the things that sold me on the car was the intelligent key fob. Its nice to not have to dig in my pocket to get my keys out. Just walk up push the button on the door handle…
Relevance: 43% Posted on: 01/27/2018
Member Credit: hamzer11 & Ghozt One word of caution to others: when I tried this method I broke a piece off my tail light. I noticed from comments on other forums a few others did as well. If you want a method of removing them without that risk you can…
Relevance: 43% Posted on: 02/21/2018
Member Credit: David Castaneda David is currently prepping for car show season and working on some very unique mods. Below is a teaser of the hood and trunk that he is working on. This post will updated with progress and ultimately the final product.
Relevance: 42% Posted on: 01/05/2017
Owner: Marvin Ramos Year: 2002 Model: Maxima Color: Beige (EV0) Trim: SE My Maxima started out as a daily until I completed my 4th. Wheels and suspension was the plan. Ordered Coilovers same night that I got the car. Ordered wheels next day. After installing I started doing other little…
Relevance: 39% Posted on: 01/13/2018
Member Credit: Bryan Tisc All of the third generation Maximas feature many standard options. The U.S. third generation Maxima came in two models, the SE and GXE. The SE, targeted a sporty end of the market while the GXE emphasized more luxury features. The SE features stiffer springs, sway bars, struts,…
Relevance: 39% Posted on: 02/10/2018
Member Credit: Sparky This 2003 Nissan Maxima came in with the complaint that the passenger front window would go down on it’s own. What I determined was that when the window was raised up, it would automatically cycle down about six inches. If the glass, motor or regulator have been…
Relevance: 38% Posted on: 12/23/2017
Member Credit: TEQ-NIQ Step 1: Remove shifter knob - Shifter knob is made of two parts, the leather handle, and the lower aluminum-looking cone-shaped piece. Grasp the cone-shaped lower piece, rotate counter-clockwise and pull down at the same time to release from shifter handle. Once this is done, there is a…
Relevance: 38% Posted on: 10/19/2020
Community Member Credit: Kevin Kryzda Tools necessary: 10mm socket and an extension Flathead screwdriver (or pry tool) Wire/Side Cutters or Wire Strippers Wire taps or soldering tools Before You Start: The purpose of this modification is to re-wire your fog light relay under your hood to receive signal from an…
Relevance: 37% Posted on: 09/15/2020
Owner: Warren Goldberg Year: 2004 Model: Maxima Color: Spirited Bronze (KY2) Engine: VQ35DE Transmission: 5-Speed Automatic This post is dedicated to Warren aka The Legendary "Ramberg". I remember back in 2007 when I first got my 6thgen Maxima, I would see posts by Warren and Chris Hernandez (aka Chernmax). I always admired their…
Relevance: 37% Posted on: 01/21/2017
Member Credit: shift_ice Over time the brake system can take on air as the effectiveness of the brake fluid decreases with age. Air can also enter the system from a leaky brake hose, a bad connection on the brake caliper, during any maintenance when a brake line is removed, or…
Relevance: 36% Posted on: 11/24/2018
Member Credit: Hawk7886 The stock speakers on the 04 Max just don't cut it for me, so I decided to take apart the rear deck and swap them out with a pair of 6X9s I had sitting around. I'm planning something with more punch in the future, but I figured…
Relevance: 36% Posted on: 01/03/2018
This car was built back in 2007. One of the very first 6thgen Maximas (if not the first) to get on Air Suspension and also go for unique look. Member Credit: Kenny aka UNFADEABLE MAX Year: 2004 Model: Maxima Color: Pearl White (QX3) Transmission: Automatic Trim: SL Full Mod List /…
Relevance: 33% Posted on: 01/08/2017
Member Credit: CXJ Performance DISCONNECT THE BATTERY FIRST! This would be great time to change the spark plugs as well. Remove the upper intake manifold. Once the manifold has been removed it will look like the picture shown below: STOP EVERYTHING! PLACE RAGS INTO THE CHAMBERS. If a bolt is dropped…
Relevance: 32% Posted on: 12/23/2017
Member Credit: thealliance43 / bambino This how-to will allow you to install an 07-08 Maxima Spoiler on your 04-06. Great mod that gives your car a sportier look. You will need the following: 1. Power Drill 2. Play-Doh 3. Drill Bit Set 4. Measuring tape. 5. Blue tape if you are…
Relevance: 31% Posted on: 12/29/2018
Member Credit: steeds Here is the P.Side all tucked with the fuse box still in the engine bay. Just for info on how to remove the Anti Skid Control Actuator clip. Pull the handle out like a drawer and it will release the clip. After tucking the wires on the P.Side…
Relevance: 31% Posted on: 11/24/2018
Member Credit: Charles Downer Tools & Materials Needed Ratcheting Wrench Screwdriver (Phillips) Wire Cutters Gauge Wire Lots of Patience REMOVING OLD SEATS: Remove bottom of rear seats held in by 4 tabs directly under that can be pulled for a quick release...that section slides out after release Remove bolts (14MM)…
Relevance: 30% Posted on: 01/21/2017
Member Credit: shift_ice NOTE: The PIAA Super Plasma fog bulbs pictured below have since been discontinued. PIAA does make the Super Plasma GT-X but they are not as good a color match as the original Super Plasma. If you have pics of the GT-X bulbs that I can post here for…
Relevance: 30% Posted on: 12/23/2017
Member Credit: 1PrjctMax! First you pop the trunk and there is ONE screw for each side that holds the rear plastic/chrome piece on. Once you take that screw out, you can carefully pop that one piece out. That's how it looks removed. Now in the front you take off the black plastic…