Search Results for: Is there any fuses under dashboard

Results 1 - 14 of 14Page 1 of 1
Results per-page: 10 | 20 | 50 | 100

5thgen Nissan Maxima Quick Guide to No-Start Problems

Relevance: 100%      Posted on: 12/02/2019

5thgen Nissan Maxima Quick Guide to No-Start Problems

Member Credit: maxiiiboy Symptom (when turning the ignition switch to START) Likely Cause No Crank, No Nothing (not even dashboard lights) If the car starts with a boost, then the battery is bad. If not, suspect the ignition switch, the battery cables, fuses, or ground/power distribution. No Crank, just a…

How to Fix a Sticking/Melting Dashboard on 7thgen Nissan Maxima 2009-2015

Relevance: 74%      Posted on: 01/31/2021

How to Fix a Sticking/Melting Dashboard on 7thgen Nissan Maxima 2009-2015

Community Member Credit: BlackCrimsonChin A little backstory: So I bought my 2012 SV used back in February. The car was sitting there for months waiting to be registered (thank you pandemic). During the height of summer, I was doing my routine engine start and realized the dashboard was blindingly shiny.…

5thgen Nissan Maxima 10AMP Meter Fuse Reference Info (Why it Keeps Blowing)

Relevance: 44%      Posted on: 12/17/2020

5thgen Nissan Maxima 10AMP Meter Fuse Reference Info (Why it Keeps Blowing)

Community Member Credit: 96SEmaxB So I started blowing this in cab 10amp fuse called meter, I checked alternator, battery, called harness lights all the normal stuff, couldn't find it, meanwhile that fuse controls the cluster and puts the vehicle into fail-safe mode... so I scoured the forums and google and…

How to Install Chrome Gauge Rings from Paradox-Systems

Relevance: 42%      Posted on: 01/25/2018

How to Install Chrome Gauge Rings from Paradox-Systems

Member Credit: shift_ice Installation procedure: 1) Remove the kick panel underneath the steering wheel. There are 2 screws at the bottom of the trim and snaps at the top. Get the screws removed and pull towards the rear of the car to release the snaps. 2) Disconnect the dimmer (and…

Preventing ECU Failures in 5thgen Nissan Maxima

Relevance: 29%      Posted on: 11/10/2019

Preventing ECU Failures in 5thgen Nissan Maxima

Member Credit: maxiiiboy (Vol.4, Spring 2017) Summary The 5th Generation Maxima is a very reliable car - if you know how to maintain it. The problem is that the car suffers from a few design defects that can make it expensive to maintain. For example, a worn-out engine mount may…

How to Install 07-08 Speedometer/Cluster on your 04-06 6thgen Maxima

Relevance: 28%      Posted on: 01/21/2018

How to Install 07-08 Speedometer/Cluster on your 04-06 6thgen Maxima

Member Credit: EddyMaxx (Additional photos/info by chrisaust and CleanMaxx) Are you looking to get rid of that orange cluster on your 2004-2006 Nissan Maxima? Well you can install an 07-08 cluster very easily as everything is plug-n-play. All you need to do is purchase a cluster with miles closest to…

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

Relevance: 25%      Posted on: 06/07/2018

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

Article Credit: EddyMaxx The videos below show you the best way to remove and replace your ABS actuator pump. It is very important that you use the SAME EXACT part number as your old one to avoid any issues. You can find them used on eBay or junkyard. I was…

Rewire Fogs to Turn-on with Parking Lights or Independently

Relevance: 24%      Posted on: 01/28/2018

Rewire Fogs to Turn-on with Parking Lights or Independently

Member Credit: 05ALTIMASE-R & Earl Johnson The key to this install is basically taking the 2 wires from the fog light switch on stalk and cutting them out of the OEM circuit. Then taking the two wires and putting one to a ground and running the other into the engine compartment to the IPDM (relay/fuse block). The last step is pulling the…

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Relevance: 22%      Posted on: 06/23/2020

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Member Credit: myer84 I finally finished installing my last mod. For a while I’ve been searching for a shift light indicator, but nothing as big as a Monster Tach or anything that would make the car look ricey. My idea of a shift light was something that would be small…

Comprehensive EGR Tube Cleaning P0400

Relevance: 21%      Posted on: 12/23/2017

Comprehensive EGR Tube Cleaning P0400

Member Credit: marktab Hi All -- thanks for the other posts on maxima.org on EGR tube cleaning. I spent several hours cleaning mine, and decided to take comprehensive pictures. Enjoy! Why are you posting so many pictures and information since this topic is often on maxima.org? The EGR Tube cleaning took…

How to Remove Dashboard on 4thgen Nissan Maxima

Relevance: 14%      Posted on: 07/22/2020

How to Remove Dashboard on 4thgen Nissan Maxima

Credit: DennisMik I would like to start by thanking JNCoRacer for his motivational pep talk. He was smart enough to know that I could do it, even though I didn't think I could. Thanks man. You will need various standard tools: screwdrivers (Phillips for screws & flat for prying), wire…

How to Install Zex Nitrous Kit

Relevance: 13%      Posted on: 01/05/2017

How to Install Zex Nitrous Kit

Source Credit: EddyMaxx These are instructions on how to install a wet nitrous kit in your 6thgen. This is pretty straight forward but if you have any doubt please take it to someone who knows how to install these systems. The Zex model used for 6thgens is usually the 82016…