Search Results for: Fuse box locations

Results 1 - 30 of 52Page 1 of 2
Results per-page: 10 | 20 | 50 | 100

5thgen Nissan Maxima Quick Guide to No-Start Problems

Relevance: 100%      Posted on: 12/02/2019

5thgen Nissan Maxima Quick Guide to No-Start Problems

Member Credit: maxiiiboy Symptom (when turning the ignition switch to START) Likely Cause No Crank, No Nothing (not even dashboard lights) If the car starts with a boost, then the battery is bad. If not, suspect the ignition switch, the battery cables, fuses, or ground/power distribution. No Crank, just a…

5thgen Nissan Maxima 10AMP Meter Fuse Reference Info (Why it Keeps Blowing)

Relevance: 62%      Posted on: 12/17/2020

5thgen Nissan Maxima 10AMP Meter Fuse Reference Info (Why it Keeps Blowing)

Community Member Credit: 96SEmaxB So I started blowing this in cab 10amp fuse called meter, I checked alternator, battery, called harness lights all the normal stuff, couldn't find it, meanwhile that fuse controls the cluster and puts the vehicle into fail-safe mode... so I scoured the forums and google and…

2004-2008 Nissan Maxima Blown Alternator Fuse Causing Brake/Battery Light

Relevance: 55%      Posted on: 11/17/2018

2004-2008 Nissan Maxima Blown Alternator Fuse Causing Brake/Battery Light

Member Credit: EddyMaxx I had recently encountered a Brake/Battery Light. The alternator checked out OK and car was driving well. After a little research, I discovered that the 10A Alternator Fuse located in the engine bay (picture below) was blown. Once I replaced it, both the Battery and Brake Light went…

Audi OEM Battery Junction Terminal Box Installed on 5thgen Nissan Maxima

Relevance: 46%      Posted on: 09/10/2020

Audi OEM Battery Junction Terminal Box Installed on 5thgen Nissan Maxima

Community Member Credit: Eddy I decided to install an Audi Battery Power Jump/Terminal Box. The engine bay is so much cleaner and I can now jumpstart the car from the engine bay vs the trunk if I ever need to. You can also see where I put the OEM battery…

5thgen Nissan Maxima Under Hood Lighting Mod DIY

Relevance: 42%      Posted on: 12/07/2019

5thgen Nissan Maxima Under Hood Lighting Mod DIY

Member Credit: TunerMax I had a free SMD LED board from HIDextra and decided to install some under hood lighting, something they should have done at Nissan. Thought I'd share this with you guys I'm sure there are quite a few of you that would be very interested in doing…

Relocate Battery & Install Cold-Air Intake on 5thgen Maxima

Relevance: 39%      Posted on: 01/10/2018

Relocate Battery & Install Cold-Air Intake on 5thgen Maxima

Member Credit: Orgullo This is the battery relocation for the 2002/2003 Nissan Maxima. However, I'm sure it will work for the other gens too since it's basically the same. I did this on my 5.5 and my boys 5.5 gen Max. This set up is for people that already have a…

How to Rewire 5thgen Fogs Light to Turn on Independently

Relevance: 38%      Posted on: 01/24/2018

How to Rewire 5thgen Fogs Light to Turn on Independently

Member Credit: shift_ice The fogs can easily be rewired to allow them to be run without the headlights. The fog light switch on the turn signal stalk still continues to turn the fogs off and on as before - the only difference is the fogs can be turned on without…

Rewire Fogs to Turn-on with Parking Lights or Independently

Relevance: 35%      Posted on: 01/28/2018

Rewire Fogs to Turn-on with Parking Lights or Independently

Member Credit: 05ALTIMASE-R & Earl Johnson The key to this install is basically taking the 2 wires from the fog light switch on stalk and cutting them out of the OEM circuit. Then taking the two wires and putting one to a ground and running the other into the engine compartment to the IPDM (relay/fuse block). The last step is pulling the…

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

Relevance: 35%      Posted on: 06/07/2018

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

Article Credit: EddyMaxx The videos below show you the best way to remove and replace your ABS actuator pump. It is very important that you use the SAME EXACT part number as your old one to avoid any issues. You can find them used on eBay or junkyard. I was…

1999 to 1995 4thgen Maxima ECM Swap a Success!

Relevance: 34%      Posted on: 07/07/2018

1999 to 1995 4thgen Maxima ECM Swap a Success!

Member Credit: whlimi I was running a cali spec ECM in my 3.5 swapped 99. I had 14 codes, most of them emissions related (damn cali spec) and TCM codes (running SSV4). Got myself a 95 5spd ECM from the junk yard and decided I would take the plunge and swap…

Engine Cover Part Numbers for 7thgen Maxima

Relevance: 31%      Posted on: 12/28/2017

Engine Cover Part Numbers for 7thgen Maxima

Member Credit: Julian Nicasio If you are looking to replace your engine covers, below are the part numbers you need. Below is the current pricing as of December 2017. You can buy them on eBay, NissanPartsDeal.com, quirkparts.com, rockauto.com.  Engine Cover 14041-9N00B $78.09 Upper Cover 64894-9N00A $50.87 Fuse box Cover 24382-ZY70A $11.28 Upper…

How to Add Heated Steering Function on 07-08 Nissan Maxima’s

Relevance: 30%      Posted on: 03/11/2018

How to Add Heated Steering Function on 07-08 Nissan Maxima's

Member Credit: Chris Goss In my 08, I put the heated steering wheel switch to the left of the steering wheel just because it was easier and shorter wire runs. Run a wire from the battery with an waterproof inline fuse holder with a 10a fuse in it. Connect that…

How to Change the Fuel Filter

Relevance: 29%      Posted on: 01/21/2017

How to Change the Fuel Filter

Member Credit: shift_ice According to Nissan the 5th Gen Maxima has a "lifetime" filter that never needs changed. In my opinion there is no such thing as a lifetime filter, so I changed mine recently. Many on maxima.org agree that a change is a good idea, and the general consensus…

How to Rewire Driving/Fog Lights on 6thgen Maxima

Relevance: 28%      Posted on: 12/31/2017

How to Rewire Driving/Fog Lights on 6thgen Maxima

Member Credit: BlackSpeed The key to this install is find the wire (negative ground) on the stalk that controls the lights. Here is the deal, the ground isn't active until the headlights are activated in return provides the ground for the coil on the relay. The two positives on the relay…

FX35 Rear Trunk Latch Door Won’t Close (Check 15A Back Door Fuse)

Relevance: 28%      Posted on: 09/27/2020

FX35 Rear Trunk Latch Door Won't Close (Check 15A Back Door Fuse)

Community Member Credit: Eddy Out of nowhere, I noticed that the trunk on my FX35 was not fully closing. Initially, I thought the actuator was toast and I would need to replace it. When you get the lock, you should be able to hear the trunk latch engage. I wasn't…

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Relevance: 27%      Posted on: 06/23/2020

LED Shift Light Install on Manual 6-speed Nissan Maxima VQ35DE

Member Credit: myer84 I finally finished installing my last mod. For a while I’ve been searching for a shift light indicator, but nothing as big as a Monster Tach or anything that would make the car look ricey. My idea of a shift light was something that would be small…

Official VQ Tuning Services for Nissan/Infiniti Vehicles | AdminTuning

Relevance: 27%      Posted on: 12/27/2019

Official VQ Tuning Services for Nissan/Infiniti Vehicles | AdminTuning

If you found this post, you are considering tuning your Nissan/Infiniti (probably a Maxima or Altima). While there are many tuners in the market, very few specialize and focus on the Maxima/Altima community. AdminTuning is the #1 go-to for these tuning services especially if you are considering using RomRaider on…

How to Install Door Handle LEDs

Relevance: 26%      Posted on: 01/08/2017

How to Install Door Handle LEDs

Member Credit: Wildman04 I did the rear door first and the rear doors are a lot easier than the front doors are to do. The rear doors will take around 45 minutes to an hour and the front doors about two hours each, so probably allow a good day for…

How to Install Umnitza Predator Thinline Angel Eyes

Relevance: 23%      Posted on: 01/25/2018

How to Install Umnitza Predator Thinline Angel Eyes

Member Credit: shift_ice Pictures simply don't do this lighting justice. Umnitza has a great product here that mimics the angel eye look found on select BMW's, and in my opinion, clearly surpasses it. The DDE's are ultra bright, very white, and an excellent compliment to the factory Maxima HIDs. Umnitza…

Preventing ECU Failures in 5thgen Nissan Maxima

Relevance: 23%      Posted on: 11/10/2019

Preventing ECU Failures in 5thgen Nissan Maxima

Member Credit: maxiiiboy (Vol.4, Spring 2017) Summary The 5th Generation Maxima is a very reliable car - if you know how to maintain it. The problem is that the car suffers from a few design defects that can make it expensive to maintain. For example, a worn-out engine mount may…

How to Nissan Maxima Fuel Pump Rewire for Increased Flow Rates

Relevance: 21%      Posted on: 12/18/2020

How to Nissan Maxima Fuel Pump Rewire for Increased Flow Rates

Community Member Credit: JIME Not sure if this has been visited before but my Son recently brought it to my attention when we were discussing running a 200 shot of spray. He suggested that I use his nitrous test kit to ensure the fuel pressure remained constant when running a…

Altima SE-R Battery Relocation and Full Wire Tuck

Relevance: 21%      Posted on: 12/29/2018

Altima SE-R Battery Relocation and Full Wire Tuck

Member Credit: steeds Here is the P.Side all tucked with the fuse box still in the engine bay. Just for info on how to remove the Anti Skid Control Actuator clip. Pull the handle out like a drawer and it will release the clip. After tucking the wires on the P.Side…

How to Install Zex Nitrous Kit

Relevance: 19%      Posted on: 01/05/2017

How to Install Zex Nitrous Kit

Source Credit: EddyMaxx These are instructions on how to install a wet nitrous kit in your 6thgen. This is pretty straight forward but if you have any doubt please take it to someone who knows how to install these systems. The Zex model used for 6thgens is usually the 82016…

How to Replace your Transmission Valve Body v2

Relevance: 18%      Posted on: 01/08/2017

How to Replace your Transmission Valve Body v2

Member Credit: rpsuprdave WARNING: It is not recommended that you attempt this procedure without basic mechanical skills and knowledge of automobiles. Always take safety precautions seriously when working around an automobile. A simple mistake may cause you physical harm and/or death. Improper installation may cause mechanical damage to the vehicle. Materials…