Search Results for: Fan relay

Results 1 - 16 of 16Page 1 of 1
Results per-page: 10 | 20 | 50 | 100

How to Rewire Driving/Fog Lights on 6thgen Maxima

Relevance: 99%      Posted on: 12/31/2017

Member Credit: BlackSpeed The key to this install is find the wire (negative ground) on the stalk that controls the lights. Here is the deal, the ground isn't active until the headlights are activated in return provides the ground for the coil on the relay. The two positives on the relay

5thgen Nissan Maxima Quick Guide to No-Start Problems

Relevance: 98%      Posted on: 12/02/2019

Member Credit: maxiiiboy Symptom (when turning the ignition switch to START) Likely Cause No Crank, No Nothing (not even dashboard lights) If the car starts with a boost, then the battery is bad. If not, suspect the ignition switch, the battery cables, fuses, or ground/power distribution. No Crank, just a…

SPAL 16″ Puller Electric Fan 2024 CFM on Nissan Maxima (Part # 30102049)

Relevance: 82%      Posted on: 06/09/2018

Member Credit: EddyMaxx I was shopping around for quality fans for my Nissan Maxima's (6thgen and 4thgen). The dual Mishimoto fans were not cutting it anymore. And honestly, the Mishimoto fans were really no different than the 14" generic ones on eBay. I did some research and found a company…

Rewire Fogs to Turn-on with Parking Lights or Independently

Relevance: 79%      Posted on: 01/28/2018

Member Credit: 05ALTIMASE-R & Earl Johnson The key to this install is basically taking the 2 wires from the fog light switch on stalk and cutting them out of the OEM circuit. Then taking the two wires and putting one to a ground and running the other into the engine compartment to the IPDM (relay/fuse block). The last step is pulling the…

How to Rewire 5thgen Fogs Light to Turn on Independently

Relevance: 73%      Posted on: 01/24/2018

Member Credit: shift_ice The fogs can easily be rewired to allow them to be run without the headlights. The fog light switch on the turn signal stalk still continues to turn the fogs off and on as before - the only difference is the fogs can be turned on without…

How to Add Heated Steering Function on 07-08 Nissan Maxima’s

Relevance: 54%      Posted on: 03/11/2018

Member Credit: Chris Goss In my 08, I put the heated steering wheel switch to the left of the steering wheel just because it was easier and shorter wire runs. Run a wire from the battery with an waterproof inline fuse holder with a 10a fuse in it. Connect that…

5thgen Maxima – Wiring Map Lights to Function When Dome Turns on

Relevance: 54%      Posted on: 12/07/2019

Member Credit: TunerMax I know some of you were interested in wiring your Map light(s) to illuminate when the Dome turned on, and some of you already have. Either way, I thought I'd let you know what I've figured out. The best way I see to do it properly: Tap…

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

Relevance: 36%      Posted on: 06/07/2018

Article Credit: EddyMaxx The videos below show you the best way to remove and replace your ABS actuator pump. It is very important that you use the SAME EXACT part number as your old one to avoid any issues. You can find them used on eBay or junkyard. I was…

How to Make Your Maxima Manumatic

Relevance: 33%      Posted on: 01/09/2017

Member Credit: Rob 1. General Overview If you can install a car alarm, you can install this kit. However, if you make a mistake, it may render your car undriveable. Please take your time and following all the test procedures listed in the installation guide. Disclaimer: Because this is a do…

Cefiro A33 TDM Nissan Maxima Folding Mirror Pinout

Relevance: 32%      Posted on: 12/16/2019

Member Credit: vastmax I acquired some genuine TDM Nissan mirrors a while ago with the convex glass, sidemarkers, puddle lights, heated, and of course, folding functionality. I ran my wires from the door to inside the car through a small grommet that is located right beside where the bundled door…

Preventing ECU Failures in 5thgen Nissan Maxima

Relevance: 23%      Posted on: 11/10/2019

Member Credit: maxiiiboy (Vol.4, Spring 2017) Summary The 5th Generation Maxima is a very reliable car - if you know how to maintain it. The problem is that the car suffers from a few design defects that can make it expensive to maintain. For example, a worn-out engine mount may…

Matt Faraca aka airmattdog’s 1997 Customized 4thgen Nissan Maxima

Relevance: 23%      Posted on: 12/29/2018

Owner: Matt Faraca aka airmattdog Year: 1997 Model: Maxima Color:  Lamborghini Orange Paint Transmission: Automatic Trim: SE Mod List: Engine: Injen Polished Cai Custom Polished Valve Cover Polished Ac Lines Polished Brake Lines Custom Polished Aluminum Relay Covers Custom Polished Maf Sensor Cover Cusco Polished Oil Catch Tank Weapon R Polished Coolant Tank Nismo Oil…

1999 to 1995 4thgen Maxima ECM Swap a Success!

Relevance: 22%      Posted on: 07/07/2018

Member Credit: whlimi I was running a cali spec ECM in my 3.5 swapped 99. I had 14 codes, most of them emissions related (damn cali spec) and TCM codes (running SSV4). Got myself a 95 5spd ECM from the junk yard and decided I would take the plunge and swap…

How to Install Umnitza Predator Thinline Angel Eyes

Relevance: 14%      Posted on: 01/25/2018

Member Credit: shift_ice Pictures simply don't do this lighting justice. Umnitza has a great product here that mimics the angel eye look found on select BMW's, and in my opinion, clearly surpasses it. The DDE's are ultra bright, very white, and an excellent compliment to the factory Maxima HIDs. Umnitza…