Search results for "Door actuator"

Results 1 - 30 of 104Page 1 of 4
Sorted by: Relevance | Sort by: DateResults per-page: 10 | 20 | 50 | All

FX35 Rear Trunk Latch Door Won’t Close (Check 15A Back Door Fuse)

[…]I wasn’t hearing. I did some research and found a quick solution. I removed the 15A – BACK DOOR fuse for 30 seconds and plugged it back in. After that, the trunk was opening and closing fine. I may have to replace the actuator soon but at least the trunk […]
Read more » FX35 Rear Trunk Latch Door Won’t Close (Check 15A Back Door Fuse)

How to Install Universal Door Actuators on 4thgen Nissan Maxima

[…]Amazon Amazon They arrived a few days ago and I began the project. I started with the rear d/side door. The universal actuators came with no instructions of any kind. Thankfully, the install for these things is fairly straightforward, and I’ll do my best to recap what I did. If […]
Read more » How to Install Universal Door Actuators on 4thgen Nissan Maxima

How to Fix Power Door Lock Actuators

[…]the foam padding. Step 2 – Once you have removed the inside panel, you should have access to the door lock actuators. Unscrew the three screws that told it in place: Step 3 – There is a wire connector on the actuator, remove it by pulling, NOT PUSHING the connector […]

How to Remove 4thgen Gen Door Panels

[…]will pop out with a bit of force. Also, having the window down helps a bit with removing the whole door panel. The last thing to remove is the doorlock/window switch connector, which can be a little stubborn, be gentle so as to not break it. Removing this black piece […]

4thgen Nissan Maxima Mode Door Motor Replacement

[…]a bad mode door motor. Found a new one online for $72 and ordered it. Genuine Nissan A/C Mode Door Actuator Motor 27731-2L900 They’re 2 types. There’s a 2-pin connector unit with a single arm and a 3-pin connector unit with a dual arm. It’s best to pull the original […]
Read more » 4thgen Nissan Maxima Mode Door Motor Replacement

How to Program your Garage Door Opener with HomeLink

[…]opener, home or office lighting, you need to be at the same location as the device. Note: Garage door openers (manufactured after 1996) have “rolling code protection”. To program a garage door opener equipped with “rolling code protection”…you will need to use a ladder to get up to the garage […]
Read more » How to Program your Garage Door Opener with HomeLink

How to Reset Flashing Airbag Light on 1995-1999 4thgen Nissan Maxima

[…]don’t start the vehicle) Within 7 seconds of turning the key to ON, push the driver’s side door switch button at least 5 times. (The DOOR SWITCH is the trigger switch for interior lights located next to your door latch on the car) The Air Bag light should go solid…give […]
Read more » How to Reset Flashing Airbag Light on 1995-1999 4thgen Nissan Maxima

How to Remove Door Panel on 2002-2006 Nissan Altima

[…]mat. Remove screws. Disconnect and remove switch plate. Remove screw beneath switch plate. Remove door finisher. If necessary, remove inner corner cover from door finisher. Installation is in the reverse order of […]
Read more » How to Remove Door Panel on 2002-2006 Nissan Altima

How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

[…]– ABS Pump Motor. I used an ABS code reader to get the codes. I picked up a working used ABS actuator from a friend for $100 bucks. It took me about 2 1/2 hours to get the job done. I removed the windshield wipers and the plastic/metal window cowl. […]
Read more » How to Replace your ABS Actuator Pump on 6thgen Maxima (2004-2008)

1998 4thgen Nissan Maxima Alarm, Remote Start, Keyless Entry Wiring

[…]Trigger Red/White (-) Low in Driver’s Kick Panel Door Lock Light Green/Red(-) Driver’s Door Door Unlock Green/Yellow (-) Double Pulse Unlock Driver’s Lock Brown/White In Driver’s Door at Switch Driver’s Unlock Brown In Driver’s Door at Switch Passenger Unlock Brown In Driver’s Door at Switch Horn Wire Green/White (-) Steering […]
Read more » 1998 4thgen Nissan Maxima Alarm, Remote Start, Keyless Entry Wiring

2002-2003 5thgen Nissan Maxima Power Window Auto-Up One Touch Function Fix

[…]simply hang the switch and handle plastic assembly to one side so you can see the inside of the door. Look inside towards the front bottom of the door behind the plastic barrier. You will see a small black switch. It almost looks like a black pan screw head. This […]
Read more » 2002-2003 5thgen Nissan Maxima Power Window Auto-Up One Touch Function Fix

How to Install L32 2007-2012 Altima LED Side Mirrors on L31 Nissan Altima SE-R

[…]need to route the wire to the front. I ran mine through the panels and through the grommet at the door. Step 4 Once all wiring is done, you will now need to mount the mirrors. Note: This is not a perfect mount. It will not be as clean and […]
Read more » How to Install L32 2007-2012 Altima LED Side Mirrors on L31 Nissan Altima SE-R

How to Install Door Handle LEDs

[…]push grommet through towards the door side and remove panel and set aside. Look behind the outer door lock inside of door cavity and you will see a yellow clip on the lock rod, roll the clip towards the front of the door and it will unclip the rod from […]

5thgen Maxima Power Window Calibration

[…]If you have already removed any of the listed parts you of course already know how to remove the door panel. Lift the screws cover in the door panel pull handle. Then using a philip’s head screwdriver remove the single screw. Lift and remove the switch trim panel. There are […]

5thgen Nissan Maxima Heated Side Mirror Installation

[…]awhile until I finally found out the reason The ECM even shows 3 wires but if you look inside the actuator, there is a wire that is split. Ok back to the subject at hand. Remove the 2 connectors (gray and black) from the actuator. Remember which go where. I […]
Read more » 5thgen Nissan Maxima Heated Side Mirror Installation

2004 6thgen Nissan Maxima with MAXI-LED Mirror Covers and LED Side Door Pockets

[…]was doing the Window Motor, I took the time to do my LED Mirror Covers and add LED’s to the side door pockets. The MAXI-LED mirror covers were created by a fellow member years ago. They were a limited run and are no longer made. I think they look great […]
Read more » 2004 6thgen Nissan Maxima with MAXI-LED Mirror Covers and LED Side Door Pockets

1995-1999 How to Disable Anti-Theft on 4thgen Nissan Maxima

[…]is closed, the system is reset. To set the system, remove the key from the ignition, and close the doors, trunk, and hood. Then lock all doors either manually using individual door lock buttons, or activate the power lock system with either the key or the multi remote control […]
Read more » 1995-1999 How to Disable Anti-Theft on 4thgen Nissan Maxima

How to Install Home Depot Front Bumper Lip Mod on 6thgen

[…]blade or scissors 2. 3M red double sided heavy duty tape about $9.00 3. 1 9 foot roll of garage door bottom seal about $10.00 Steps: 1. Put the 3M tape on the door seal. 2. Clean the bottom of your bumper where the lip is going. 3. Start removing […]
Read more » How to Install Home Depot Front Bumper Lip Mod on 6thgen

4thgen Nissan Maxima How to Remove and Install Exterior Door Handles

[…]Make sure the window is rolled up before beginning work. 2. Remove all accessories on the inner door panel. Remove door panel and set aside with accessories. 3. Peel away the majority of the weather covering – you’ll need a lot of room to work. 4. Remove the three bolts […]
Read more » 4thgen Nissan Maxima How to Remove and Install Exterior Door Handles

How to Get Rid of The Door Chime on 5thgen Nissan Maxima

[…]interfering with my music. But I didn’t want to lose the car’s ability to know when the door opened/closed (for lock and alarm purposes.) I still like seeing the “door-open” visual indicator; and i don’t like cutting OEM harness wires if I don’t have to. My method involves removing the […]
Read more » How to Get Rid of The Door Chime on 5thgen Nissan Maxima

2002-2003 Nissan Maxima Keyless Entry Remote Key Fob Programming Instructions (Super Easy)

[…]be successful. If there are any remaining remotes (including working ones), Unlock then Lock all doors using the switch on the driver’s door panel. Within 5 seconds of locking and unlocking doors press the LOCK button on the next remote. Your hazard lamps will flash. Repeat this step for each […]
Read more » 2002-2003 Nissan Maxima Keyless Entry Remote Key Fob Programming Instructions (Super Easy)

5.5 Gen Maxima Front Component and Rear Speaker Replacement

[…]back on and your ready to get crackin with the fronts  THE FRONTS 1. Refer to step 1 in rear doors and remove front door panel. 2. Remove the A-Pillar, its help by to clips Here we see the pathetic stock tweeter…i had to put on my grandmothers glasses to […]
Read more » 5.5 Gen Maxima Front Component and Rear Speaker Replacement

Ryan aka lowvybez2demax’s Modified 2002 5thgen Nissan Maxima

[…]with Navigation (4) 10″ Rear Deck Midbass Speakers (2) 6.5″ Front Door Speakers (2) 8″ Rear Door Speakers Audiopipe AQX 300.4 for Rear Deck Crunch 1800.4 for Door Speakers Clarion EQ Clarion Crossover Audiocontrol Epicenter TEIN SS Coilovers 300ZX Big Brake Kit 19″ Infiniti G35 […]
Read more » Ryan aka lowvybez2demax’s Modified 2002 5thgen Nissan Maxima

Starlight Headliner Installed on 1998 4thgen Nissan Maxima

[…]u can crack it but i didnt crease or crack mine. When I finally put it back in, I took the sunroof door out from the backside near the rear window it comes out with 2 little tabs that unscrew on the top of the brackets that hold the sunroof […]
Read more » Starlight Headliner Installed on 1998 4thgen Nissan Maxima

2009-2015 Nissan Maxima Intelligent Key Programming Instructions

[…]Intelligent Key. WHAT ARE THE BENEFITS OF THE NISSAN INTELLIGENT KEY? Lock and unlock your doors and trunk without using your Nissan Intelligent Key. So long as your key is on your person, all you’ll need to do is press the “Request Switch” button on your door or trunk to […]
Read more » 2009-2015 Nissan Maxima Intelligent Key Programming Instructions

How to Change Cabin Filter on 2003-2008 Infiniti FX35

[…]IN OUR CARS, SO MAKE SURE YOU INSTALL YOUR FILTER PROPERLY). NOTE: WHEN PUTTING THE FILTER COVER (DOOR) BACK ON YOU WILL NEED TO LIFT THE FILTER UP WHILE CLOSING THE COVER, THE DOOR HAS TABS ON IT AND THE FILTER NEEDS TO SIT ABOVE THESE […]
Read more » How to Change Cabin Filter on 2003-2008 Infiniti FX35

2005 Nissan Maxima, Park/Tail Lights Do Not Work, Fuse Blows (Dome Light Switch Issue)

[…]connector, some heat shrink tubing and the dome light works as most people expect anyway. Open the door and it comes on. Close the door and it turns off. Slight delay since it is a Nissan design. They prefer their dome lights to fade out gradually. So if you have […]
Read more » 2005 Nissan Maxima, Park/Tail Lights Do Not Work, Fuse Blows (Dome Light Switch Issue)